[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: [bluetooth-dev] hi, hw-dependencies, and local uart-speed
We had similar problems with the Ericsson hw. We fixed the problem by
changing the DEFAULT_SPEED in the btd.c to 57600 and then we added a
"set_ericsson_baudrate(DEFAULT_SPEED)" command after the "quit command".
This sets the baudrate back to the 57600 if you exit the btd(user), you can
also reset the Ericsson hw at any time.
Where can I find Ericsson's own HCI-commands like used in the
set_ericsson_baudrate function (ogf=3f)?
[mailto:email@example.com]On Behalf Of Oliver Kasten
Sent: 19. lokakuuta 2000 18:26
Subject: [bluetooth-dev] hi, hw-dependencies, and local uart-speed
i'm new to the list, so: hi everbody!
i came across an irritation while changing btd (learning by pulling
things apart und putting them back together upside down):
whenever i restart btd(user) i have to reset the ericsson module
(manually) to reset its uart speed to the default value. otherwise
communications with the bt-hw fails. that's because the stack always
sets the local serial port speed to the hw default (in init_phys(...) in
btd.c:1119 ). however, the bt-hw might already be set to another speed
by the previous instance of btd(user).
imho there sould be an additional option (say "-ls <speed>") for the
serial port speed used when first talking to the bt-hw (i.e. the speed
the bt-hw is set to when starting the stack).
this leeds to another question: why isn't there a command in the _menu_
to change the uart speed? i'd like to implement that. however, there
seems to be a catch for ericsson hw when changing uart speed
/* wait for HW... must be sure we have sent whole message before
changing baudrate on serial port but we must change serial baudrate
before the result returns if using P9A modules, why are the P9A
ericsson modules not sending the result back on same uart speed ?!?!?
after setting the new baudrate "set_ericsson_baudrate(spd);" there is a
fixed wait "usleep(10000)". as of now this code is only called when the
baudrate is set to the hw default (56.7kbps). would the factor have to
be a different one when starting from a different baudrate? does it
depend on other conditions (requests pending, buffer status, etc.)? are
there conditions when uart-speed changes are illegal?
ps.: i found the hardware-depended code is pretty scattered in the
source files. there is ericsson specific functions in btd.c, hci.c and
bluetooth.c. i feel that hw-specific code should be put into one source
file per hw-device supported.
Oliver Kasten phone: +41/ 1/ 63-2 06 63
ETH-Zurich fax: +41/ 1/ 63-2 16 59
Haldeneggsteig 4, IFW D48.1 email: firstname.lastname@example.org
CH-8092 Zuerich, Switzerland http://www.inf.ethz.ch/~kasten/