[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [bluetooth-dev] Serial Connection for Axis stack



you mean this

http://www.inf.ethz.ch/~kasten/research/bathtub/bluetooth/tmp/P000027F.JPG
http://www.inf.ethz.ch/~kasten/research/bathtub/bluetooth/tmp/P000026G.JPG

applikation kit?

i didn't do the setup, but apparently Vin (+5V, red clamp clipped to the
outward green wire) goes to pin 1 (edge of the board next to the reset
switch) and ground goes to pin 10.

DISCLAIMER: ... everything might be wrong ... no liability whatsoever
... expressed or implied ... ;)

good luck!
o*


"Catherine Mulligan (ECS)" wrote:
> 
> Thanks, it's been driving me nuts!

-- 
Oliver Kasten                                phone: +41/ 1/ 63-2 06 63
ETH-Zurich                                     fax: +41/ 1/ 63-2 16 59
Haldeneggsteig 4, IFW D48.1                  email: kasten@xxxxxxx.ch
CH-8092 Zuerich, Switzerland           http://www.inf.ethz.ch/~kasten/
-
To unsubscribe from this list: send the line "unsubscribe bluetooth-dev" in
the body of a message to majordomo@xxxxxxx.com