[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [bluetooth-dev] Serial Connection for Axis stack



And you want to remove the jumper. The jumper is factory set to USB. It 
runs fine on my power supply (around 25 mA)...

jb

>>>>>>>>>>>>>>>>>> Original Message <<<<<<<<<<<<<<<<<<

On 28/11/2000, 19:14:13, Oliver Kasten <kasten@xxxxxxx.ch> wrote regarding 
Re: [bluetooth-dev] Serial Connection for Axis stack:


> you mean this

> 
http://www.inf.ethz.ch/~kasten/research/bathtub/bluetooth/tmp/P000027F.JPG
> 
http://www.inf.ethz.ch/~kasten/research/bathtub/bluetooth/tmp/P000026G.JPG

> applikation kit?

> i didn't do the setup, but apparently Vin (+5V, red clamp clipped to the
> outward green wire) goes to pin 1 (edge of the board next to the reset
> switch) and ground goes to pin 10.

> DISCLAIMER: ... everything might be wrong ... no liability whatsoever
> ... expressed or implied ... ;)

> good luck!
> o*


> "Catherine Mulligan (ECS)" wrote:
> >
> > Thanks, it's been driving me nuts!

> --
> Oliver Kasten                                phone: +41/ 1/ 63-2 06 63
> ETH-Zurich                                     fax: +41/ 1/ 63-2 16 59
> Haldeneggsteig 4, IFW D48.1                  email: kasten@xxxxxxx.ch
> CH-8092 Zuerich, Switzerland           http://www.inf.ethz.ch/~kasten/
> -
> To unsubscribe from this list: send the line "unsubscribe bluetooth-dev" 
in
> the body of a message to majordomo@xxxxxxx.com
-
To unsubscribe from this list: send the line "unsubscribe bluetooth-dev" in
the body of a message to majordomo@xxxxxxx.com