[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [bluetooth-dev] Interface to ETRAX-100LX



Hi Vilas.

We will soon make a release of a new development board called
Development Board for Bluetooth. This board will have Bluetooth chip
installed and ready to use. This chip is connected directly to Etrax' 
serial port. We will also release a schematic. Please be patient.

Regards
/Magnus

-----Original Message-----
From: Vilas Uchil [mailto:vilas@xxxxxxx.edu]
Sent: den 6 december 2001 06:25
To: bluetooth-dev@xxxxxxx.com
Subject: [bluetooth-dev] Interface to ETRAX-100LX


Hello everyone

I am in the process of interfacing the bluetooth chip with axis ETRAX-100LX.
I followed the procedures for porting a large application into the axis
board and was successful in flashing the kernel of ETRAX-100LX with the axis
OpenBT stack.
I am still a beginner in the OpenBT and would like to know how do I proceed
with the interface after that. Should I straight away connect the BT module
to the serial port or is there any other procedure for me to follow for the
actual hardware interface.
Can someone out there provide me with some reference as to how to begin with
the actual hardware interface.

Cheers
Vilas Uchil

-
To unsubscribe from this list: send the line "unsubscribe bluetooth-dev" in
the body of a message to majordomo@xxxxxxx.com
-
To unsubscribe from this list: send the line "unsubscribe bluetooth-dev" in
the body of a message to majordomo@xxxxxxx.com