[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: 16M SDRAM & 32M SDRAM



Axis board is connected only to my PC.
So, before upgrading memory, there is no problem in using [./ktest], [./flashitall] and [./flashit]

I have question why board can boot through [./ktest] but [./flashitall].

That's I don't understand.



-----Original Message-----
From: owner-dev-etrax@xxxxxxx.com]On">mailto:owner-dev-etrax@xxxxxxx.com]On Behalf Of Tobias Anderberg
Sent: Tuesday, November 06, 2001 4:56 PM
To: Jihoon Bang
Cc: dev-etrax@xxxxxxx.com
Subject: Re: 16M SDRAM & 32M SDRAM


Jihoon Bang wrote:

> Hi. all
>
> I am using  ETRAXLX100 board which have 16M SDRAM and 4M(2 units of 2Mbyte flash rom) Flash memory.
> To upgrade memory from 16M to 32M, I modified DRAM size and R_DRAM_Config in xconfig.
>
> DRAM size 16 => 32
> R_DRAM_Config 00e03636 => 009e05757 ( 32bit, 0 group, 4 banks, 9 column addr., 12 row addr.)
>
> After [make kernel], It works well using [./ktest.]
> I could connect to board using telnet.
> In proc/meminfo, There are about 32M available memory.
> but, [./flashitall] doesn't work.
> [./flashitall] makes boot log, but after final log, it stops
> I couldn't use telnet or ftp, maybe board halted.

This happens because ./flashitall resets IP and MAC to our factory
defaults. Use the arp+ping to set them and you should be up and
running again.

/tobba