[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: how i add an usb conenctor ?



Michaela.
You need to enable USB Host Port 2 under "Drivers for ETRAX 100LX built-in interfaces"
when you configure the kernel. Please note that the ETRAX 100LX USB host driver is not fully
implemented (isochronous traffic is not yet supported in the driver for instance). We are right 
now improving the host driver and it will be released as soon as possible. 

I would also like to make it clear that the ETRAX 100LX USB controller supports all four traffic 
types both in host and device mode.
Earlier versions of ETRAX 100LX had a couple of USB related bugs but these are no longer present.

Regards
/Magnus  

-----Original Message-----
From: Michaela Bone [mailto:blutus@xxxxxxx.net]
Sent: den 16 april 2002 09:54
To: Magnus Mårtensson
Subject: Re: how i add an usb conenctor ?


thanks i have seen bunt how i have (with wich new options regarding usb) to
compile the new kernel ?


----- Original Message -----
From: "Magnus Mårtensson" <magnus.martensson@xxxxxxx.com>
To: "'Michaela Bone'" <blutus@xxxxxxx.com>
Sent: Monday, April 15, 2002 5:06 PM
Subject: RE: how i add an usb conenctor ?


> Hi Michaela.
>
> Please have a look at
> http://developer.axis.com/doc/hardware/devboard_lx/USB_Devboard_LX.pdf
<http://developer.axis.com/doc/hardware/devboard_lx/USB_Devboard_LX.pdf>
> for instructions.
>
> Regards
> /Magnus
>
> -----Original Message-----
> From: Michaela Bone [mailto:blutus@xxxxxxx.net]
> Sent: den 15 april 2002 17:03
> To: dev-etrax@xxxxxxx.com
> Subject: how i add an usb conenctor ?
>
>
> hi
>
> i have the developer lx board...
> how i add an usb connector ?
>
> thx
>