[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Re. Add device



Have you enabled parallel port support in the kernel?

-----Original Message-----
From: owner-dev-etrax@xxxxxxx.com]On">mailto:owner-dev-etrax@xxxxxxx.com]On Behalf Of
Kangning
Sent: Friday, June 28, 2002 11:53 AM
To: dev-etrax
Subject: Re. Add device



Hello,
 
Thank you so much for your help. I have added the device into the list.
 
However, I have got a new problem of opening the device. I cannot even open
the /dev/lp0 on devboard. Can you tell me what is going wrong here?
 
Thanks a lot.
 
Best regards,
 
Wang Kangning

----- Original Message ----- 
From: Mikael Starvik <mailto:mikael.starvik@xxxxxxx.com>  
To: 'Kangning' <mailto:engp1764@xxxxxxx.sg>  ; dev-etrax
<mailto:dev-etrax@xxxxxxx.com>  
Sent: Wednesday, June 26, 2002 6:43 PM
Subject: RE: Add device

Hi,
 
You must add the enty in the dev directory. For an example take a look in
e.g.
packages/param/axis-2.4/Makefile
 
/Mikael

-----Original Message-----
From: owner-dev-etrax@xxxxxxx.com">mailto:owner-dev-etrax@xxxxxxx.com>
[mailto:owner-dev-etrax@xxxxxxx.com]On Behalf Of Kangning
Sent: Wednesday, June 26, 2002 12:09 PM
To: dev-etrax
Subject: Add device


Dear All,
 
I have written a parallel driver and have it added, following the
instructions for LCD driver,  into the devboard_lx/target/dev/ directory.
Then after I ./flashit, I could not find the device under /dev in the
etrax_100lx board. Can anybody tell me why I cannot have the device under
/target/dev ported into the board's flash? Any extra configuration I should
do? Thanks in advance.
 
I am sure I have flashed the memory, since the network setting is reset to
default.
 
Regards,
 
Wang Kangning