[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: boot loader not working after reboot host - more info



It sounds that you haven't put the board in boot mode properly.
Can you access the board using HTTP when you believe you have
it in boot mode?
(In that case it isn't in boot mode)
Make  sure you release the reset button (led turns on) before
you release the boot button. The buttons are marked 'R' and 'B'
on the PCB.

/Johan


----- Original Message -----
From: "Dave Rovner" <david.rovner1@xxxxxxx.net>
To: "Lars Viklund" <larsv@xxxxxxx.com>
Cc: <dev-etrax@xxxxxxx.com>
Sent: den 25 november 2002 01:36
Subject: RE: boot loader not working after reboot host - more info


> I have just re-installed the devboard software, the linux source, and
> rebuilt all the images. When I try to run flashit - it hangs. My
application
> on the board is still present. Is there a special method to get back to
some
> factory defaults on the axis board, so I can rule out the board? And what
> would the defaults be?
>
> TIA
>
> Dave Rovner
> ACT
>
>
>
>
> -----Original Message-----
> From: owner-dev-etrax@xxxxxxx.com]On">mailto:owner-dev-etrax@xxxxxxx.com]On
> Behalf Of Lars Viklund
> Sent: Sunday, November 24, 2002 5:01 PM
> To: Dave Rovner
> Cc: dev-etrax@xxxxxxx.com
> Subject: RE: boot loader not working after reboot host - more info
>
>
>
> On Sun, 2002-11-24 at 21:59, Dave Rovner wrote:
> > I turned on the terminal login and df'd the system. It claims to have no
> > room left in "flash3". Is this a problem?
>
> No.
>
> > I can however access the board via http [i still have the boa enabled in
> > inittab]. Is there a setting i can change through the home page by
> browsing
> > the file system that will help?
>
> No.
>
> The boot loader uses the on-chip boot code and the content of the flash
> will not affect the boot procedure. Since it worked fine until you
> rebooted your PC the problem is probably on the PC side.
>
>