[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Upgrade to 2.4.19



Did you run the patch on an existing tree or a new tree?
Anybody out there that has similar problems?

I can build a tree and run the patch in different places in 
my filesystem but my computer may be tainted.

/Mikael

-----Original Message-----
From: owner-dev-etrax@xxxxxxx.com]On">mailto:owner-dev-etrax@xxxxxxx.com]On
Behalf Of silver@xxxxxxx.se
Sent: Monday, November 25, 2002 2:56 PM
To: dev-etrax
Subject: Upgrade to 2.4.19



Hello,

Has anyone else in the group had problems when upgrading from linux 2.4.14
to 2.4.19? I get errors when I attempt to compile the kernel. Some complaints
that I get while applying the supplied patches seem to refer to files in
Mikael Starvik's own directory that are not available. I skip over these
patches, but then the kernel compilation stops with errors before
completion. Has anyone else seen these problems (and fixed them)?

I need the 2.4.19 upgrade to use the new gpio functions.

On another note, when compiling the 2.4.14 kernel, I noticed that the default
configuration for the serial ports (on the development_lx board) is ports
0 and 3 enabled, 1 and 4 disabled. Shouldn't ports 0 and 1 be enabled?

Regards,

Sam Silverstein
silver@xxxxxxx.se