[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: USB problem on devboard_lx



Hi,

Try to enable CONFIG_PARTITION_ADVANCED and CONFIG_MSDOS_PARTITION
in the File systems -> Partition Types.

Tibor Bodolai
BBOX

> -----Original Message-----
> From: owner-dev-etrax@xxxxxxx.com]On">mailto:owner-dev-etrax@xxxxxxx.com]On
> Behalf Of kangjerjyh
> Sent: Thursday, February 27, 2003 10:38 AM
> To: dev-etrax@xxxxxxx.com
> Subject: Fw: USB problem on devboard_lx
> 
> 
> HI:
>     I have solved problem about USB.
>     I enable wrong USB port ,it should be port2  ,not port1....:)
> 
>     but I got new problem now :(.
>     I try to use USB mass stoage according to
> http://mhonarc.axis.se/dev-etrax/msg02546.html
>     but I fail....
>     the following is kernel log
>     I notice that there is an error message on "partion check "
>     what reason could result in this condition ??
>     Any suggestion is welcome,thanks.
>     (sorry I am poor in english)
> 
>     ---------------------------------
>     hub.c: USB new device connect on bus1/2, assigned device number 2
> scsi0 : SCSI emulation for USB Mass Storage devices
>   Vendor: ALLCAN    Model: Quick Disk        Rev: 1.11
>   Type:   Direct-Access                      ANSI SCSI revision: 02
> Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
> SCSI device sda: 64512 512-byte hdwr sectors (33 MB)
> sda: Write Protect is off
> Partition check:
>  sda: unknown partition table
> WARNING: USB Mass Storage data integrity not assured
> USB Mass Storage device found at 2
> --------------------------------------------