[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: multiplxed data/address bus interface



Hi
Im using the parallel port par0 to inteface with SJA1000 CAN controller
with ETRAX 100LX(developer board). But I havent tested them together.Im
doing only by software jet.
There is an example in "AN97076.pdf" from philips.

Ion Cadierno

----- Original Message -----
From: "Abdul R Rafiq" <arafiq@xxxxxxx.com>
To: <dev-etrax@xxxxxxx.com>
Sent: Saturday, July 19, 2003 4:11 AM
Subject: multiplxed data/address bus interface


>
> I am trying to interface SJA1000 CAN controller with the MCM dev
> board.  This 8-bit device uses multiplxed data and address bus and uses
> the ALE signal to latch the address. I would like to know if there is
> any reference design example available that shows how to interface
> these type of devices with the ETRAX100LX chip.
>
> regards,
>
> Abdul
>
>
>