[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Problems changing debugger to serial0


The kernel tries to open the debug port to be used as /dev/console
but you have disabled all serial ports. If you want no debug you
should select disabled on Product debug port. If you want debug
on serial port 2, Serial port support must be enabled.


-----Original Message-----
From: owner-dev-etrax@xxxxxxx.com">mailto:owner-dev-etrax@xxxxxxx.com] On Behalf Of Ion Cadierno
Sent: Thursday, July 24, 2003 11:28 AM
To: dev-etrax
Subject: Problems changing debugger to serial0


I want to use port PA to do an interrupt in developer board. A have changed the debugger from serial2 to serial0 doing

make xcongif
Hardware setup->Product debug port ->serial0
	      ->Product rescue port->serial0
Drivers ETRAX100LX buitl in interfaces->Serial port support (disabled) 

When I start ./sermon and Etrax starts I see this:

I2C driver v2.2, (c) 1999-2001 Axis Communications AB
EEPROM char device v0.3, (c) 2000 Axis Communications AB
eeprom: Assuming i2c compatible 2kB eeprom.
ETRAX 100LX GPIO driver v2.2, (c) 2001 Axis Communications AB
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
kmem_create: Forcing size word alignment - ip_dst_cache
IP: routing cache hash table of 1024 buckets, 8Kbytes
TCP: Hash tables configured (established 1024 bind 1024)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
VFS: Mounted root (cramfs filesystem) readonly.
Freeing unused kernel memory: 32k freed
Warning: unable to open an initial console.
eth0: changed MAC to 00:40:8C:CD:00:00

and it doesnt continue.
Could you help me why it doesnt continue an I cant start a terminal sesion?

Thanks in advance