[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: RE: Flash-Problem / No startup
It looks like the problem we had.
Effekt: flashing worked but reboot caused hangup with both leds on
Reason: Ram address typo
took us some time to find :)
- - - - - - - - - - - - - - Original Message - - - - - - - - - - - - - -
From: Mikael Starvik <firstname.lastname@example.org>
Subject: RE: Flash-Problem / No startup
Date: 06/16/04 09:59
try boot_linux -F -p. There should be several --setreg options.
Do you run RedHat?
It could be another UTF-8 problem.
and start the installation from scratch.
Memory configuration of a developer board LX is
From: Markus Wentker [mailto:email@example.com]
Sent: Wednesday, June 16, 2004 9:39 AM
To: Mikael Starvik
Subject: Re: Flash-Problem / No startup
No, this was the complete DEBUG-Output.
I didn't change anything when re-flashing the Devboard.
Also made "make clean" and then "make kernel & make images"
However I will check this.
Where can I check the RAM Configuration?
I found in the mailing-archiv that this is done by kernelconfig.
What is the correct value for a DevboardLX?
Many thanks in advance.
> >Here is the debugging-out from the serial-port:
> >Checksum of file is 0x00000000
> This is not normal. There should more SET_REGISTERs. Did you cut them?
> A failure when jumping to 0x00000000 normally indicates a RAM
> configuration error. My first shot would be to do a complete remake
> to be sure. Or download some other software that you know has worked
> -----Original Message-----
> From: firstname.lastname@example.org">mailto:email@example.com] On Behalf
> Of Markus Wentker
> Sent: Tuesday, June 15, 2004 3:20 PM
> To: dev-etrax
> Subject: Flash-Problem / No startup
> We have a problem with our DevboardLX.
> Just in work it hung up and then didn┤t started up again.
> The Processor and RAM was very hot this time. Maybe the sun did the best it
> could this time....
> We tried to flash it again, but nothing worked...
> Here is the debugging-out from the serial-port:
> Checksum of file is 0x00000000
> CFI dev 0x80000000
> No 1x CFI at 0x84000000
> No single x16 at 0x84000000
> No interleaved x16 at 0x84000000
> 0x80000000: Erasing 0x00200000 bytes...done, verifying...OK
> 0x80000000: Writing 0x00200000 bytes...verified
> JUMP 0x00000000
> After this the board doesn┤t start. Both LEDs (the yellow and orange one)
> light all the time.
> I┤m wondering about the Checksum of 0x0000000.
> Is there something broken on the board.