[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Problem flashing axis 82



Title: RE: Problem flashing axis 82

The sequence of button pushes were correct. The problem was that the linux box was not on the same subnet: 101.* vs. 103.*. Hence, this was the reason why the broadcast messages weren't being picked up. Now it is resolved.

-----Original Message-----
From: Mark Richards [mailto:mark.richards@xxxxxxx.com]
Sent: Thursday, August 05, 2004 12:00 PM
To: 'Gurkan, Ozzie [ERS/ATL]'
Cc: dev-etrax@xxxxxxx.com
Subject: RE: Problem flashing axis 82

That sequence seems strange.  Is it supposed to be (1) Hold Reset (2) hold boot (3) release Reset (4) release boot ?

Nothing comes out of the ttyS0 port on my unit, either.  I think it's normal while the unit is waiting for an image.

Mark Richards

-----Original Message-----
From: owner-dev-etrax@xxxxxxx.com">mailto:owner-dev-etrax@xxxxxxx.com] On Behalf Of Gurkan, Ozzie [ERS/ATL]
Sent: Thursday, August 05, 2004 09:50
To: dev-etrax@xxxxxxx.com
Subject: Problem flashing axis 82


I put the Axis board in "boot" mode by pressing the button closest to the serial port connector and then pressing reset. The green light flashes and then I let go of the boot button. Now, nothing comes out of the COM1 port. I can't ping it, so the box isn't listening anymore. I run kflash from my linux box (that I telnet into), which is running on the same subnet, however, nothing happens. Am I missing something? Does the board have to be hooked directly to the linux box? I can see activity on my switch where Axis is plugged into but nothing is happening. Does anyone have suggestions?

Thanks,

Emerson Retail Services
Gurkan, Ozzie [ERS/ATL]
Manager, Integrated Systems
OGurkan@xxxxxxx.com
1640 Airport Rd., Suite 109
Kennesaw, GA 30144
tel: 6786311925
mobile: 4046413381


Add me to your address book...