[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: BUSCLK



    Hello again,
        Can I use SDRAMCLK for this purpose ? I suppose it is a 100 MHz
clock signal for SDRAM devices but I think it is possible to use it for LCD
controller :)  What do you think about it ?.

----- Original Message ----- 
From: "Mikael Starvik" <mikael.starvik@xxxxxxx.com>
To: "'Martin Fake'" <martinfake_76@xxxxxxx.com>; "dev-etrax"
<dev-etrax@xxxxxxx.com>
Sent: Monday, August 23, 2004 9:58 AM
Subject: RE: BUSCLK


BUSCLK is not intended to clock peripherals. If you need a clock for
e.g. a FPGA you should clock it separately and use handshaking or
similar between the CPU and the FPGA. For simple peripherals
it is enough to get a chip select and a read/write strobe.

Regards
/Mikael

-----Original Message-----
From: owner-dev-etrax@xxxxxxx.com">mailto:owner-dev-etrax@xxxxxxx.com] On Behalf
Of Martin Fake
Sent: Sunday, August 22, 2004 2:10 PM
To: dev-etrax
Subject: BUSCLK


     Hello,
         I need a clock signal for peripherals. I have seen a BUSCLK (C15)
pin in BUS signals group. But I have not found enough information about this
pin. Is it a clock output for peripherals or for only test signal ?

Martin